A-1212 Wifi Modbus TCP - Multifunction IO Unit -2DI, 4AI, 2DO, 2AO

£114.00

(£136.80 Inc. VAT)

Add USB Programming Lead

+ £3.50

6 in stock, immediate despatch

–

The A-1212 is a Wifi Remote Modbus TCP module with 2 digital inputs, 2 analogue Inputs (0/4 to 20 mA), 2 PT100 Analogue Inputs, 2 transistor digital outputs and 2 analogue outputs. It uses optical isolators to prevent ground loop effects and limits damages from power surges. The A-1219 has a Wifi port supporting Modbus/TCP communications as well as a RS485 port for Modbus RTU. A USB comm port is also available for Modbus communications and configuration.

2 x Digital Inputs (with opto Isolation)
2 x Digital Outputs: (Souce Transistor rated 1A @ 10-35VDC)
2 x Analogue input Type: 0-20mA, 4-20mA
ADC Resolution: 16-bit
2 x PT-100/PT1000
Temperature Ranges: (PT-100:-200~+600°C), (PT-1000:-200~+600°C)
2 x Analogue Outputs: (12-bit)
Analogue Outputs Type: 0-20mA, 4 -20mA
Input Impedance:
- Current: 100 Ω
- RTD : 10 MΩ
Input Accuracy: ±0.1%
Sampling Rate: 10 sample/second (total)
CMR @ 50/60 Hz: 120 dB
Output state pre-settable on Comms fail
Output state pre-settable on power-up
Wifi - Standard 2.4GHz IEEE 802.11 b/g
Modes:
- AP Access Point - connect directly
- Remote - connect via Wifi network
Supplied with removable antenna
RS-485 Interface
USB Interface for configuration and test
Protocol - Modbus/TCP, Modbus RTU
Operating Temperature: - 20 to 75º C
Power: 10 to 30VDC, 24VAC
Panel or DIN Rail mount - stackable for high density applications
Dimensions - 72mm x 118mm x 39mm

Included Software

The unit is configured using the free Utility Software. This can be used to set the units' IP address and to set the input ranges and monitor inputs.

Optional Software

DAQFactory

DAQFactory is a low cost data acquisition and control software for SCADA, Factory Automation, HMI and Test and Measurement applications. DAQFactory provides all the tools needed to acquire data, log it, share it on a network, display it on the screen, graph it, analyse it, and automate your project. DAQFactory can communicate with just about any serial or Ethernet device using Modbus RTU, ASCII or Modbus/ TCP. It also supports a wide variety of DAQ devices including LabJack USB devices and many other DAQ cards.

Downloads

Analogue Inputs

Digital Inputs